RBA hold rates at record lows in March

RBA hold rates at record lows in March
RBA hold rates at record lows in March

The March meeting of the RBA has seen the cash rate remain on hold at 1.5 percent.

It has now stayed at record lows for 28 consecutive meetings. 

The last time the rate changed was in August 2016.

CoreLogic's head of research Tim Lawless says there is a growing possibility that rates could fall later this year. 

"The strong labour market report for January was likely a key factor in keeping rates on hold, however in balance, wages have grown at a consistently low rate growth and inflation remains stubbornly below the target range," Lawless said.

"The sharp slowdown in residential construction activity and relatively benign retail trade figures may be hinting that weak housing market conditions are already spilling over to the broader economy. 

"No doubt the RBA are tracking housing market conditions very closely, watching for any further deterioration that might signal a dent to consumer spirits, resulting in less spending, more saving and a further pull back in residential construction activity. 

"CoreLogic reported another broad based decline in dwelling values in February, down 0.7% nationally, however the good news was that the rate of decline has eased over the past two months and housing affordability is showing a consistent improvement across most housing markets.  

"The performance of the housing sector over coming months should provide some clues about future monetary policy decisions. 

"A further deterioration in the pace or geographic scope of declines could tip the balance in favour of a rate cut later this year as the RBA becomes wary of the wealth effect moving into reverse.

Joel Robinson

Joel Robinson

Joel Robinson is a property journalist based in Sydney. Joel has been writing about the residential real estate market for the last five years, specializing in market trends and the economics and finance behind buying and selling real estate.

Rba Rate Decision Rba Insights

Community Discussion

Be the first one to comment on this article
What would you like to say about this project?